Installation of your Telraam in 11 steps
1. Plug the power cable into the side of the Telraam (as shown) and then plug it into the wall socket. When the Telraam is powered, the red light will light up continuously and the green light will start blinking. After a while the green light will be off. The red light must remain on continuously.
Enter the password:
Once your mobile device is connected to Telraam Wi-Fi, you will get a message saying that you are connected but do not have internet. This is not a problem.
a. Cars on the house side
b. Cars at the opposite side
c. Bicyclists on house side
d. Bicyclists at the opposite side
e. Pedestrians at house side
f. Pedestrians at the opposite side
With the recent v11 (September 2021) a progress bar appears and there is an automatic check of the entered wifi data.
In the less recent v10, this check does not take place. You are therefore dependent on the web platform. If, after about 10-15 minutes, data comes in on the web platform, then the Wi-Fi data is correct..
If the connection was unsuccessful, there is probably a typo error or the wrong network has been selected. Please try again.